Home Contact Us

ADVERTISEMENT

Precision - My Experience - MT267

Posted: Feb 16th, 2020 - 10:34 am In Reply to: PRECISION TRANSCRIPTION - LAURA

I worked for this company about 4 years ago, when I was looking for work. At that time, worked was pooled in such a way that you might get a ST job and the next job would be VR. ALL MTs were expected to do VR work. However, the owner had her "favorites" that were allowed to skip over the VR work and just do straight typing. When I called her out on it, instead of sending out an email to the ICs about it, I was terminated. For her and this company, this has been going on since day one.

ADVERTISEMENT

Post A Reply Reply By Email Options

Use Rich Text Editor with Full Options CLOSE

Edit/Delete Message

Report this message

Complete Discussion Below: (

marks the location of current message within thread)

PRECISION TRANSCRIPTION - LAURA (Views: 1425, 2020-02-15, 10:29 pm)
- Precision - Lisa (Views: 978, 2020-02-16, 9:07 am)
- Precision - My Experience - MT267
- Precision - Who is the owner (Views: 1042, 2020-02-16, 11:50 am)
  - Owner - MT267 (Views: 1335, 2020-02-16, 11:55 am)
    - Owner of Precision - Thank you (Views: 1183, 2020-02-16, 12:51 pm)
    - PRECISION TRANSCRIPTION - Laura (Views: 1069, 2020-02-17, 5:54 am)
- Bitter much?? - So sorry you (Views: 976, 2020-02-17, 3:10 pm)
  - Two years is a long time, not being able to cut it probably - not issue, sm (Views: 768, 2020-02-18, 7:59 am)
    - Can't say I agree - with (Views: 1018, 2020-02-19, 2:36 am)
      - Can't say I agree with you either. Freedom of speech, my kind words - nm (Views: 720, 2020-02-19, 4:06 pm)
- I see a lot of inconsistencies with QA - sm (Views: 832, 2020-02-17, 5:31 pm)
  - KS QA KitKat Bar - PLAINTIFF (Views: 952, 2020-02-17, 10:42 pm)
    - This is about Precision not KS - NM (Views: 820, 2020-02-18, 12:25 am)
      - sorry, sounds like KS - PLAINTIFF (Views: 730, 2020-02-18, 9:58 pm)
- I like Precision - sm (Views: 766, 2020-02-19, 12:09 pm)
  - Some insight. - sm (Views: 800, 2020-02-19, 12:43 pm)
  - Precision - Beth (Views: 596, 2020-06-08, 9:13 am)
- Precision? - CEMT (Views: 725, 2020-03-11, 1:46 pm)