Home Contact Us

ADVERTISEMENT

Precision - Lisa

Posted: Feb 16th, 2020 - 9:07 am In Reply to: PRECISION TRANSCRIPTION - LAURA

I worked for them. I did not last 2 years. I was let go as my work was not up to their quality. I have over 25 yrs experience but found that jumping around from specialty to specialty was challenging and apparently above my abilities. I find it hard to believe that other MTs that work there do not have a hard time handling the demands of the job, but perhaps it is just me. The whole experience left my confidence pretty much shot.

ADVERTISEMENT

Post A Reply Reply By Email Options

Use Rich Text Editor with Full Options CLOSE

Edit/Delete Message

Report this message

Complete Discussion Below: (

marks the location of current message within thread)

PRECISION TRANSCRIPTION - LAURA (Views: 1425, 2020-02-15, 10:29 pm)
- Precision - Lisa
- Precision - My Experience - MT267 (Views: 1134, 2020-02-16, 10:34 am)
- Precision - Who is the owner (Views: 1043, 2020-02-16, 11:50 am)
  - Owner - MT267 (Views: 1335, 2020-02-16, 11:55 am)
    - Owner of Precision - Thank you (Views: 1183, 2020-02-16, 12:51 pm)
    - PRECISION TRANSCRIPTION - Laura (Views: 1069, 2020-02-17, 5:54 am)
- Bitter much?? - So sorry you (Views: 976, 2020-02-17, 3:10 pm)
  - Two years is a long time, not being able to cut it probably - not issue, sm (Views: 769, 2020-02-18, 7:59 am)
    - Can't say I agree - with (Views: 1018, 2020-02-19, 2:36 am)
      - Can't say I agree with you either. Freedom of speech, my kind words - nm (Views: 720, 2020-02-19, 4:06 pm)
- I see a lot of inconsistencies with QA - sm (Views: 832, 2020-02-17, 5:31 pm)
  - KS QA KitKat Bar - PLAINTIFF (Views: 952, 2020-02-17, 10:42 pm)
    - This is about Precision not KS - NM (Views: 820, 2020-02-18, 12:25 am)
      - sorry, sounds like KS - PLAINTIFF (Views: 730, 2020-02-18, 9:58 pm)
- I like Precision - sm (Views: 767, 2020-02-19, 12:09 pm)
  - Some insight. - sm (Views: 800, 2020-02-19, 12:43 pm)
  - Precision - Beth (Views: 596, 2020-06-08, 9:13 am)
- Precision? - CEMT (Views: 725, 2020-03-11, 1:46 pm)